Network Addon Mod 31.2 Update Their Dependencies

They may be used on their own, or optionally powered by IC2 or RFFE energy and controlled by computers from Computercraft or Open Computers.

Put a configurator in your right hand, sneak-right-click the gate base and then sneak-right-click the designated DHD.

This feature will also allow server admins to pre-program common addresses into it.

This feature works slightly different when used in combination with the PDD.

Feature is optional, not required unless you want to use PDD, Configurator and GDO.

Sneak-Right-Click the base of a Stargate then Sneak-Right-Click the DHD.

You will see messages regarding saved location and created link.

This means you can copy and share the items using various methods.

The GUI will also show and error state if issues were encountered during dialing as well as allow the user to disconnect the gates wormhole.

Otherwise at the moment it is based on the players ability to modify the Stargates base block itself.

Sneak-right-click the base of the Stargate with a Configurator and then sneak-right-click a DHD to create a link.

Additional permission nodes required for each option, see configurations list below.

If the player doesnt have admin access to the stargate then the non-inventory GUI window will appear with only the gate address shown.

Added option to kill an entity in the event they attempt to reverse travel through a one-way wormhole.

This is a hand-held tool that is used to store gate addresses.

How the device works is that within the GUI you can manually add, edit and remove gate addresses.

These entries are unique to the item itself except for the values that can be pre-programmed into the PDD device via the pdd.yml configuration file.

You can easily add new addresses to a PPD by sneak-right-clicking a stargate with a PDD.

This handheld device also allows you to set familiar names to gate addresses.

Now go to the DHD you want to link the gate to and then sneak-right-click the DHD.

Any value greater than 0 means transport between the point of origin and the destination requires the usage of a ZPM.

The value also is used as a multiplier to configure how much additional power is required to make the initial connection.

Network Addon Mod 31.2 Update Their Dependencies

If they arent tell them to stop being lazy and update their dependencies.

You can typically figure out which mod is causing the issue by looking for this line in your latest.log file: SpongePowered MIXIN Subsystem Version0.7.4 Sourcefile: Following this line will point to the exact filemod that loaded the Mixin system.